Bernina Sewing Machine - Manual (Page 14)

Setting up the sewing computer 14
Inserting the bobbin
... it lies in the T-shaped slit at
the end of the spring.
The bobbin must turn clock-
wise when thread is pulled. Insert the bobbin
Insert the bobbin so that the
thread runs clockwise. Pull the thread counter clock-
wise into the slot. Pull the thread to the left
under the spring until ...
Removing the needle
• raise the needle
• turn power switch to 0
• lower the presser foot
•
loosen the needle clamp screw
•
pull the needle down to remove
Inserting the needle
• flat side of needle to the back
• insert the needle as far as it will go
• tighten the needle clamp screw
Changing the needle
Refer to the safety instruction!
activa 125 (GB) 4.12.2002 14:16 Uhr Seite 14
030595.50.04_0201_a125_EN