Bernina Sewing Machine - Manual (Page 49)

49 Faults
Trouble shooting
Upper thread breaks
•
The upper thread tension is
too tight.
•
The needles are of a poor
quality. Ideally needles should
be purchased from your
BERNINA dealer.
• The needle is bent or blunt.
• Poor quality, knotted or dried
out thread has been used.
•
Use the correct spool disc.
•
Stitch plate or hook tip
damaged. Take your sewing
computer to your BERNINA
dealer.
Lower thread breaks
•
The lower thread tension is
too tight.
•
The bobbin is jamming in the
bobbin case. Remove and
replace the bobbin.
• The hole in the stitch plate
has been damaged by the
needle. This must be
repolished by an expert.
•
The needle is blunt or bent.
Skipped stitches
• Wrong needles used. Use only
130/705H system.
• The needle is blunt, bent or
incorrectly inserted.
•
Push right to the top when
inserting.
•
Needle inserted all the way to
the top.
• The needle point does not suit
the fabric being sewn. If
necessary use a ball point for
knitted fabrics and cutting
point for hard leather.
Needle breaks
• Needle clamp screw loose.
• Fabric taken out in front
instead of behind presser foot.
•
When sewing over thick area,
the fabric was pushed with
the needle still in the fabric.
•
Poor quality thread, unevenly
wound or knotted.
• See pages 42–44 for infor-
mation about needles
In most cases you will be able to identify and remedy faults by
checking the following.
Check whether:
• the upper and lower threads are threaded correctly
• the needle is inserted correctly
• the needle size is correct – check the needle/thread table p. 42
•
the sewing computer is clean – brush out any thread fluff
•
the hook race is clean
•
any threads are trapped between the tension discs or under the
bobbin case spring
• the bobbin runs smoothly in the case or if remnants or lint need
removing
Faulty stitching
• Remnants of thread between
the tension discs.
• Remnants of thread under the
bobbin case spring.
•
Lower thread still threaded in
the bobbin case finger.
•
Sewing computer threaded
with foot down.
• Incorrect threading. Check
upper and lower threads.
• Use the correct spool disc.
Sewing computer fails to run
or runs slowly
• Plug not properly inserted.
• Power switch in off position.
• Sewing computer has been
standing in a cold room.
•
Bobbin winder still switched
on.
activa 125 (GB) 4.12.2002 14:16 Uhr Seite 49
030595.50.04_0201_a125_EN