Toshiba Equium L20 - Manual (Page 114)

6-12 User’s Manual
Power and Power-Up Modes
Installing the battery pack
To install a battery, follow the steps below.
1. Turn the computer’s power off.
2. Disconnect all cables connected to the computer.
3. Insert the battery pack.
4. Ensure the battery release lock (1) is moved into its locked position.
Securing the battery pack
Power-up modes
The computer has the following power-up modes:
■ Boot Mode: Computer shuts down without saving data. Always save
your work before you turn the computer off in boot mode.
■ Hibernation Mode: Data in memory is saved to the hard disk.
■ Standby Mode: Data is maintained in the computer’s main memory.
Windows ® utilities
You can specify the setting in the Windows ® Power Options.
Hot keys
You can use hot keys Fn + F3 to enter Standby Mode and Fn + F4 to enter
Hibernation Mode. Refer to Chapter 5, The Keyboard for details.
■ The battery pack is a lithium ion battery, which can explode if not
properly replaced, used, handled or disposed of. Dispose of the battery
as required by local ordinances or regulations. Use only batteries
recommended by TOSHIBA as replacements.
■ Do not touch the latch while holding the computer. Or you may get
injured by the dropped battery by unintentional release of the latch.
Battery Release
Lock (1)
Battery pack
Refer also to the sections Turning on the power and Turning off the power
in Chapter 3, Getting Started .