Toshiba Equium L20 - Manual (Page 59)

User’s Manual 3-5
Getting Started
Installing the battery pack
To install a battery, follow the steps below.
1. Turn the computer’s power off.
2. Disconnect all cables connected to the computer.
3. Insert the battery pack. The Battery Release Latch (2) clicks into place.
4. Secure the Battery Release Lock (1) to ensure the battery is locked into
place. Later, when you want to remove the battery you must disengage
this lock first.
Securing the battery pack
■ The battery pack is a lithium ion battery, which can explode if not
properly replaced, used, handled or disposed of. Dispose of the battery
as required by local ordinances or regulations. Use only batteries
recommended by TOSHIBA as replacements.
■ Do not touch the latch while holding the computer. Or you may get
injured by the dropped battery by unintentional release of the latch.
■ Please do not push the power button before installing the battery pack.
Battery Release
Lock (1)
Battery Release Latch (2)
Refer to Removing the battery pack section in Chapter 6, Power and
Power-Up Modes , for removing the battery pack.