Toshiba HV10 - Manual (Page 12)

12
Activating the Noise Reduction
If the receiving signal is weak and the picture is blurry,
the picture may be improved when using this function.
1 In the PICTURE menu, press B or b to select Noise
Reduction.
2 Press C or c to select Off , Low, Middle or High.
Sound controls
Setting the MTS (Multi-channel TV Sound)
Auto mode
The MTS Auto mode automatically recognize stereo/
bilingual programmes depending on the broadcast
signal.
1 Press MENU / C c to highlight SOUND icon.
2 Press B or b to select MTS.
OK Enter
SOUND
MTS
Dual
Bass
Treble
Balance
Audio Level Offset
Auto
0
0
0
0
Dual 1
3 Press C or c to select Auto or Mono.
Mono mode
If you experience noise or poor reception of any stereo/
bilingual programme, set the MTS mode to Mono.
Noise will be reduced and reception may improve.
NOTE: If you experience noise with a particular
programme on whose channel reception is usually good,
try setting MTS mode to Auto, then switch
s to e
Mono (monaural).
Reset
1 In the PICTURE menu, press B or b until Reset is
selected and press OK.
Selecting the Dual 1 or Dual 2 mode
You can hear only Dual 1 or Dual 2 sound selected,
whenever bilingual programmes are received.
1 In the SOUND menu, press B or b to select Dual.
2 Press C or c to select Dual 1 or Dual 2.
NOTE:
• When the MTS setting is in Mono mode, the Dual
menu is not selectable.
• The Dual menu setting status remains even if the TV is
turned off .
Adjusting the sound quality
You can adjust the basic sound quality.
1 In the SOUND menu, press B or b to select an item
you want to adjust.
2 Press C or c to adjust the settings as required.
Selection C Pressing c
Bass weaker stronger
Treble weaker stronger
Balance decreases the right
channel decreases the left
channel
Adjusting Audio Level Off set
Sometimes there can be large changes in volume when
switching from an ATV channel or an external input.
Using this feature reduces these volume diff erences.
1 In the SOUND menu, press B or b to select Audio
Level Off set and press OK.
2 Press B or b to select an option and press C or c to
adjust the volume level.
CONTROLS AND FEATURES