Toshiba NB300 - Manual (Page 102)

User’s Manual 8-7
Optional Devices
Removing a memory module
To remove the memory module, follow the steps as detailed below:
1. Turn the computer off and remove all cables connected to the
computer.
2. Turn the computer upside down and remove the battery pack (refer to
Chapter 6, Power and Power-up Modes .)
3. Remove one screw securing the memory module cover.
4. Lift off the memory module cover.
5. Push the latches outward and the memory module will pop up.
6. Grasp the memory module by the sides and pull it out.
7. Seat the memory module cover in place and secure it with one screw.
8. Install the battery pack - refer to
Replacing the battery pack section in
Chapter 6, Power and Power-up Modes , if required.
9. Turn your computer over.
Battery Packs
You can increase the portability of the computer with additional battery
packs so that, if you're away from an AC power source and your battery
runs low, you can replace it with a freshly charged battery. Please refer to
Chapter 6, Power and Power-up Modes for further information.
Universal AC Adaptor
If you frequently use your computer at more than one site, it may be
convenient to purchase an additional AC adaptor to be kept at each site in
order to remove the need to always carry the adaptor with you.
USB floppy diskette drive
The 3 1/2" external FDD module can be connected to the USB port.
USB optical disc drive
The USB Optical Disc Drive can be connected to the USB port.