Eu conformity statement, Ce compliance, Working environment – Toshiba NB300 User Manual
Page 3
User’s Manual
iii
mini NB300/NB305
MultiMediaCard and MMC are trademarks of the MultiMediaCard
Association.
Other trademarks and registered trademarks not listed above may be used
in this manual.
EU Conformity Statement
This product is carrying the CE-Mark in accordance with the related
European Directives. Responsible for CE-Marking is TOSHIBA Europe
GmbH, Hammfelddamm 8, 41460 Neuss, Germany. The complete and
official EU Declaration of Conformity can be found on TOSHIBA’s web site
http://epps.toshiba-teg.com
on the Internet.
CE compliance
This product is labelled with the CE Mark in accordance with the related
European Directives, notably Electromagnetic Compatibility Directive
2004/108/EC for the notebook and the electronic accessories including the
supplied power adapter, the Radio Equipment and Telecommunications
Terminal Equipment Directive 1999/5/EC in case of implemented
telecommunication accessories and the Low Voltage Directive 2006/95/EC
for the supplied power adapter. This product and the original options are
designed to observe the related EMC (Electromagnetic Compatibility) and
safety standards. However, TOSHIBA cannot guarantee that this product
still observes these EMC standards if options or cables not produced by
TOSHIBA are connected or implemented. In this case the persons who
have connected/implemented those options/cables have to provide
assurance that the system (PC plus options/cables) still fulfils the required
standards. To avoid general EMC problems, the following guidance should
be noted:
■
Only CE marked options should be connected/implemented
■
Only best shielded cables should be connected
Working environment
This product was designed to fulfil the EMC (Electromagnetic Compatibility)
requirements to be observed for so-called "Residential, commercial and
light industry environments". TOSHIBA do not approve the use of this
product in working environments other than the above mentioned
"Residential, commercial and light industry environments". For example,
the following environments are not approved:
■
Industrial Environments (e.g. environments where a mains voltage of
380 V three-phase is used)
■
Medical Environments
■
Automotive Environments
■
Aircraft Environments