Toshiba Tecra M11 User Manual

Page 27

Advertising
background image

User’s Manual

1-9

Getting Started

Benefits of Sleep Mode

The Sleep Mode feature provides the following benefits:

Restores the previous working environment more rapidly than does the

Hibernation Mode feature.

Saves power by shutting down the system when the computer receives

no input or hardware access for the time period set by the System

Sleep Mode feature.

Allows the use of the panel power off feature.

Executing Sleep Mode

You can enter Sleep Mode in one of three ways:

Click Start, point to the arrow icon (

) and then select

Sleep from the menu.

Close the display panel. Please note that this feature must be enabled

within the Power Options (to access it, click Start  Control Panel 

System and Security  Power Options).

Press the power button. Please note that this feature must be enabled

within the Power Options (to access it, click Start  Control Panel 

System and Security  Power Options).

Before entering Sleep Mode, be sure to save your data.

Do not install or remove a memory module while the computer is in

Sleep Mode. The computer or the memory module could be damaged.

Do not remove the battery pack while the computer is in Sleep Mode

(unless the computer is connected to an AC power source). Data in

memory could be lost.

When the AC adaptor is connected, the computer will go into Sleep

Mode according to the settings in the Power Options (to access it,

Start  Control Panel  System and Security  Power Options).

To restore the operation of the computer from Sleep Mode, press and

hold the power button or any key on the keyboard for a short amount of

time. Please note that keyboard keys can only be used if the Wake-up

on Keyboard option is enabled within the HW Setup utility.

If the computer enters Sleep Mode while a network application is

active, the application might not be restored when the computer is next

turned on and the system returns from Sleep Mode.

To prevent the computer from automatically entering Sleep Mode,

disable Sleep Mode within the Power Options (to access it, Start 

Control Panel  System and Security  Power Options).

To use the Hybrid Sleep function, configure it in the Power Options.

You can also enable Sleep Mode by pressing FN + F3 - please refer to

Chapter 5,

The Keyboard

, for further details.

Advertising