Toshiba Tecra R10 - Manual (Page 172)

8-20 User’s Manual
TECRA R10
LAN
Wireless LAN
If the following procedures do not restore LAN access, consult your LAN
administrator. For more information on wireless communication, refer to
Chapter 4,
Operating Basics .
When the display panel and an external monitor
are set to clone mode and they are turned off by
the timer, the display panel or the external
monitor may not display when turned on again.
If this occurs, press FN + F5 to re-set the display
panel and external monitor to clone mode.
Display error occurs Check that the cable connecting the external
monitor to the computer is firmly attached.
If you are still unable to resolve the problem,
contact your reseller, dealer or service provider.
Problem Procedure
Problem Procedure
Cannot access LAN Check for a firm cable connection between the
LAN jack and the LAN hub.
Wake-up on LAN does
not work Make sure the AC adaptor is connected. The
Wake-up on LAN function consumes power even
when the system is off.
If problems persist, consult your LAN
administrator.
Problem Procedure
Cannot access
Wireless LAN Make sure the computer’s Wireless
communication switch is set to on.
Wake-up on Wireless
LAN does not work Make sure the AC adaptor is connected. The
Wake-up on Wireless LAN function consumes
power even when the system is off.
If problems persist, contact your LAN
administrator.