Toshiba ML933 - Manual (Page 19)

19
SETTING UP YOUR TV
Engl
ish n
Press OK. If your country supports Network Guide,
The Guide Type screen will appear.
Press
C
or
c
to select Broadcast Guide or
MediaGuide.
NOTE: If you select MediaGuide, it may take time to
access the Guide screen depending on active channel
numbers.
o
Press OK. If the Ant/Cable In screen appears, press
B
or
b
to select Antenna or Cable, and then press OK
to check ( ).
p
Select Next and press OK. The Auto Tuning start up
screen will appear with the option to select between
DTV and ATV, DTV or ATV if available. Use
C or c to
select the appropriate mode.
q
Press B or b to highlight Start Scan, and then press
OK.
The television will start to search for available DTV
and/or ATV channels. The progress bar will indicate
the scan status.
You must allow the television to complete the
search.
When the search is complete, the television will
automatically select channel one.
The Auto Tuning screen will display the total number
of services found.
r
Press
C
or
c
to view the DTV (digital channel) or ATV
(analogue channel) lists.
s
Use
B
or
b
to move through the list to select a
channel, and then press OK to view.
In ATV mode, some areas may receive duplicate
stations. There may not be a clear picture or the signal
may be weak, so the station order can be changed
using ATV Manual Tuning.
REMEMBER: Press TV at any time to select between
ATV and DTV modes.
NOTE: The time will be set automatically by
transmission but can be advanced or decreased by
using Local Time Setting in the DTV Settings screen.
From this menu, you can set the RF input configuration.
a
Press MENU / C c to highlight Setup icon.
b
Press
B
/
C c
to highlight System Setup icon and
press OK.
c
Press b to select Ant/Cable In and press C or c to
select Antenna or Cable.
NOTE: When you attempt to change the Ant/Cable
In setting, a warning message will appear followed by
PIN entry (if PIN has been set) and a prompt for Auto
Tuning.
d
When Ant/Cable In is set to Cable, the following
setting options will be provided in the Auto Tuning
screen.
Press
B
or
b
to select an item and press
C
or
c
to
select your desired option.
Guide Type
Broadcast Guide
Please select Guide Type.
Ant/Cable In
Cable
Next
Antenna
Auto Tuning - Antenna
Progress Found
ATV Tune Waiting...
: C7 Channel
DTV Tune 3 % 2
Ant/Cable In (if available)
PLEASE NOTE
The Quick Setup menu can also be accessed at any
time from the Setup / System Setup menu.
Auto Tuning - Cable
DTV and ATV Tuning Mode
DTV
Others Operator Selection
Quick Scan Scan Type
Auto Start Frequency
Auto End Frequency
Auto Modulation
Auto Symbol Rate
Auto Network ID
Start Scan