Nokia N80 - Manual (Page 100)

Tools
99
User name —The user name may be needed to make a data
connection, and is usually provided by the service provider.
Prompt password —If you must enter the password every
time you log in to a server, or if you do not want to save
your password in the device, select
Yes .
Password —A password may be needed to make a data
connection, and is usually provided by the service provider.
Authentication —Select Normal or Secure .
Homepage —Depending on the access point you are setting
up, enter the Web address or the address of the multimedia
messaging center.
Select Options > Advanced settings to change the
following settings:
Network type —Select the Internet protocol type to use:
IPv4 settings or IPv6 settings . The other settings depend
on the selected network type.
Phone IP address (for IPv4 only)—Enter the IP address of
your device.
DNS address —In Primary name serv.: , enter the IP address
of the primary DNS server. In Second. name server: , enter
the IP address of the secondary DNS server. Contact your
Internet service provider to obtain these addresses.
Proxy serv. address —Define the address for the proxy
server.
Proxy port number —Enter the proxy port number.
Wireless LAN
Follow the instructions from your service provider.
WLAN netw. name —Select Enter manually or Search for
netw. . If you select an existing network, WLAN netw.
mode and WLAN security mode are determined by the
settings of its access point device.
Network status —Select whether the network name is
shown.
WLAN netw. mode —Select Ad-hoc to create an ad hoc
network and to allow devices to send and receive data
directly; a wireless LAN access point device is not needed.
WLAN security mode —Select the encryption used: WEP ,
802.1x (not for ad hoc networks), or WPA/WPA2 (not for
ad hoc networks). If you select Open network , no
encryption is used. The WEP, 802.1x, and WPA functions
can be used only if the network supports them.
WLAN security sett. —Enter the settings for the selected
security mode:
Security settings for WEP :
Wep key in use —Select the WEP key number. You can
create up to four WEP keys. The same settings must be
entered on the wireless LAN access point device.