Braun UVL 604XB - Manual (Page 18)

Page 16
Note: The lift platform must be
pushed back into its carriage
compartment at least half-way
before reverting back to normal
(powered) operation. When the
lift is fully extended manually, it
does not activate the proper
switches for normal operation.
Returning (moving) the lift at least
half-way in allows for proper
switch activation.
Note: Before manually raising or
lowering platform, be sure to
reengage the release cable
mechanism by loosening (turning)
the “T” handle and pushing
inward. Failure to place “T”
handle in the original IN position
will allow the platform to move in
and out when trying to raise or
lower the platform with the hand
pump.
Sales Representative: Instruct
and demonstrate the proper re-
engagement procedure of the
manual release for all new UVL
owners at the point of sale or
delivery. Remind the consumer of
proper engagement procedures
when giving telephone instructions.
Step-by-step instructions for
manually moving the platform in
and out, manually raising and
lowering the platform and manually
lowering (unfolding) the outboard
roll stop are provided on the
following pages.
After manually moving the
platform in or out:
1. Turn (loosen) the manual
release “T” handle.
2. Push the “T” handle in fully
(until handle bottoms out
against its mounting bracket).
Platform Carriage Assembly Drive Chain Reengagement Procedure:
3. Grasp the outer roll stop and
move the platform in and out
until the platform locks (chain
release assembly engages),
securing the platform carriage
assembly within the housing.
You will feel the release
mechanism engage.
Manual Operating Instructions
WA RN
ING
81823
Push T-handle in fully and
manually move platform in
and out to engage platform
lock before driving vehicle.
Failure to lock platform may
result in unintended platform
deployment. Unintended
platform deployment may
result in serious bodily injury
and/or property damage.
Do not remove!
TO LOCK
TURN
Read warning posted above!
1. Pull the “T” handle release
cable outward.
2. Turn the “T” handle to lock
platform into the released
position.
3. Carefully pull the platform out
to desired position.
To Manually Move Platform Out (Extend) From Stow Position:
Read warning posted above!
Before raising or lowering the
platform, be sure to lock the
platform. Reengage the release
cable mechanism by loosening
(turning) the “T” handle and
pushing inward. Failure to place
“T” handle in the original IN
position (lock platform) will cause
the platform to move in and out
when trying to raise or lower the
platform with the hand pump.
WA
RN ING
81823
Push T-handle in fully and
manually move platform in
and out to engage platform
lock before driving vehicle.
Failure to lock platform may
result in unintended platform
deployment. Unintended
platform deployment may
result in serious bodily injury
and/or property damage.
Do not remove!
TO LOCK
TUR N
2
1
2
1
WARNING
Push T-handle in fully and
manually move platform in
and out to engage platform
lock before driving vehicle.
Failure to lock platform may
result in unintended platform
deployment. Unintended
platform deployment may
result in serious bodily injury
and/or property damage.