Braun UVL 604XB - Manual (Page 21)

Page 19
Manual Operating Instructions
To Manually Move Platform Inward (Retract) To Stow Position:
Read Platform Carriage Assem-
bly Drive Chain Reengagement
Procedure section on page 16!
1. Position (raise or lower)
platform to stow level (height)
using procedures outlined on
pages 17 and 18.
2. Pull “T” handle release cable.
See Figure 1.
3. Turn “T” handle to lock plat-
form in the released position.
See Figure 1.
4. Carefully push platform
inward to stow position.
5. Reengage the release cable
mechanism by a. turning the
“T” handle and b. pushing the
the “T” handle in fully (see
Figure 2). Grasp the outer roll
stop and move the platform in
and out until the platform
locks. You will feel the
release mechanism engage.
CAUTION
Push roll stop down
switch inward when
inserting detent pin.
Failure to do so will
result in switch break-
age.
WA RN
ING
81823
Push T-handle in fully and
manually move platform in
and out to engage platform
lock before driving vehicle.
Failure to lock platform m
ay
result in unintended platform
deployment. Unintended
platform deploym
ent may
result in serious bodily injury
and/or property damage.
Do not remove!
TO LOCK
TURN
Figure 1
2
3
WA RN
ING
8182 3
Push T-handle in fully and
manually m
ove platform in
and out to engage platform
lock before driving vehicle.
Failure to lock platform may
result in unintended platform
deployment. Unintended
platform deployment may
result in serious bodily injury
and/or property damage.
Do not remove!
TO LOCK
TURN
a
b
Figure 2
The automatic outboard roll stop is powered by an
electric actuator. In the event of power or equip-
ment failure, refer to the following instructions to
manually operate the roll stop.
Note: The lift will not raise from ground level if the
roll stop actuator detent pin has not been rein-
stalled. The detent pin fully engages and activates
the roll stop down switch.
Caution: Push
the roll stop down
switch inward
(toward vehicle)
before inserting the
detent pin. Details
on following page.
Failure to do so
will result in
switch damage.
Outboard Roll Stop Manual Operation
Roll Stop
Roll Stop Actuator Roll Stop Down Switch
Detent Pin Hairpin Cotter
WARNING
Push T-handle in fully and
manually move platform in
and out to engage platform
lock before driving vehicle.
Failure to lock platform may
result in unintended platform
deployment. Unintended
platform deployment may
result in serious bodily injury
and/or property damage.