Braun UVL 604XB - Manual (Page 19)

Page 17
Manual Operating Instructions
A
Hand
Pump
Hand Pump Handle
Release Valve
maximum
30 inch lbs
minimum
15 inch lbs
seats
(stops)
O
P
E
N
C
L
O
S
E
approximate 1/16" intervals
Valve Tightening Specification:
Once valve seats (stops), tighten
15 to 30 inch pounds as shown.
WA
RN ING
81823
Push T-handle in fully and
manually move platform in
and out to engage platform
lock before driving vehicle.
Failure to lock platform may
result in unintended platform
deployment. Unintended
platform deployment may
result in serious bodily injury
and/or property damage.
Do not remove!
TO LOCK
TU RN
Figure 1 Figure 2
WA
RN ING
8182 3
Push T-handle in fully and
manually move platform in
and out to engage platform
lock before driving vehicle.
Failure to lock platform may
result in unintended platform
deploym
ent. Unintended platform
deployment may result in serious bodily injury
and/or property damage.
Do not remove!
TO LO CK
TURN
Open
(Down)
Close
(Up/Stop)
B
C
b
a
a
b
Hand Pump Handle
To Manually Raise Platform
To Floor Level:
Note: Disregard procedures for
manually moving the platform in or
out if not applicable.
1. Remove pump handle from
clips on side of power pack (or
other storage location).
2. Place handle through pump
cover access slot and into hand
pump. Stroke hand pump until
platform reaches floor height
(see Photo C).
3. a. Pull “T” handle release cable
outward and b. turn “T” handle
to lock platform into the re-
leased position (see Figure 1).
4. Push platform in until it meets
floor of vehicle (if applicable).
5. Reengage the release cable
mechanism by a. turning the “T”
handle and b. pushing the “T”
handle in fully (see Figure 2).
Note: Grasp the outer roll stop
and move the platform in and
out until the platform locks.
You will feel the release mecha-
nism engage. Read Platform
Carriage Assembly Drive
Chain Reengagement Proce-
dure section on opposite page!
Release
Valve