Sharp CV-P10PR - Manual (Page 11)

GB-9
ENGLISH NOTES ON OPERATION
• Allow 3 minutes for the compressor to restart cooling.
If you turn the unit off and immediately restart it, allow three minutes for the compressor
to restart cooling. There is an electronic device in the unit that keeps the compressor
turned off for three minutes for safety.
• When power failure occurs
This air conditioner has a memory function to store settings when a power failure occurs.
After power recovery, the unit will automatically re-start in the same settings which were
active before the power failure, except for timer settings.
If a power failure occurs while the timer is set, the timer setting will be cancelled and will
not be retrieved even after the power is restored.
• Low temperature operation: Is your unit freezing up?
Freezing may occur when the unit is set close to 18°C in low ambient temperature condi-
tions, especially at night.
In these conditions, a further temperature drop may cause the unit to freeze.
Setting the unit to a higher temperature will prevent it from freezing.
• Dry mode increases room temperature.
The unit generates heat during dry mode and the room temperature will rise. Warm air
will be blown out from the Exhaust air outlet, but this is normal and does not indicate a
problem with the unit.
• This unit blows the warm air generated by the unit outside the room via the ex-
haust hose while in cool mode.
Accordingly, the same amount of air as that is blown out will enter the room from outside
through any openings into the room.
• When cooling operation is performed at high humidity conditions, water tank in-
side the unit may frequently become full.
When water tank inside the unit is full, the unit stops operating and the orange TIMER,
the green AIR CON and the red MAXIMUM lamps will blink. In this case, perform
drainage to drain out water within the unit.
OPERATING CONDITIONS
• The unit must be operated within the following temperature range.
Mode Room temperature
Cool 18°C - 40°C
Dry 15°C - 40°C
• A built-in safety device may cut off operation if the temperature exceeds these limits.
• When cooling operation is performed at high room temperature, the fan may run at a
slower speed.
ENERGY EFFICIENCY TIPS
• Avoid direct sunlight.
Close blinds, drapes or shades to keep out direct sunlight while in cooling mode.
• Keep the filter clean.
Keeping the filter clean greatly aids efficient operation. A dirty filter blocks the flow of air,
making your unit work harder and less efficiently.
NOTE ON OPERATION
01_CV-P10PR_OM_EN.indd 9 14/08/29 16:42