Sharp IG-A10EU-W - Manual (Page 10)

E-8
SPECIFICATIONS
TROUBLESHOOTING
*The target fl oor surface area for which an emitted airborne ion density of about 25,000 ions/cm 3 can
be measured at a point near the center of the room (at a height of about 1.2 m from the fl oor), during
operation at the HIGH mode when the main unit is placed near a wall.
• The number of ions will vary according to the room conditions and the main unit operation mode.
Model
Power supply
Power consumption (W)
Airfl ow volume (m3/hour)
Applicable fl oor surface area (m2)*
Power cord (m)
Outer dimensions (mm)
Weight (kg)
220-240V, 50/60Hz
(High) 14.0
(High) 102
10
1.8
2.5
IG-A10EU
(Low) 6.5
(Low) 72
Problem WHAT TO DO
The Plasmacluster Ion Generator
does not work.
Make sure to put in the plug.
Approx. 2 years and 2 months (approx. 19,000
hours) has been passed.
Replace with a new Plasmacluster Ion
Generating Unit. See page E-6,7.
Plasmacluster Ions are not released.
Press the Operation button and restart.
Failure
Unplug and contact the store you purchased or
Sharp Service Center.
The discharged air has odor. The Plasmacluster Ion Generator releases a
small trace of ozone which may produce odor.
This is not harmful to health.
A clicking or ticking sound comes
from the unit while operating the
Plasmacluster Ion Generator.
Loudness can be changed depending on a room
humidity, but the effectiveness is the same.
Relocate the Plasmacluster Ion Generator if
necessary.
fl ashing faster
(red)
fl ashing (red)
fl ashing (blue)
fl ashing (blue)
fl ashing (blue)
Before calling for service, please review the TROUBLESHOOTING chart below,since the problem may
not be Plasmacluster Ion Generator malfunctions.
If all lights keep fl ashing, replace with new
Plasmacluster Ion Generating Unit. See page E-6,7.
• Dust may block the fi lter, clean the fi lter.
140 160 345 (W D H)
IG-A10EU.Eng.indd 10 IG-A10EU.Eng.indd 10 2009/06/17 10:37:19 2009/06/17 10:37:19