Sharp LL-S201A User Manual

Page 11

Advertising
background image

5. QUICK SUMMRY OF THE FEATURE

5.1. Firmware version up (Version UP)

The controller software of LL-S201A is updated if necessary.

5.2. Setting the destination of model (MODEL)

The destination setting is set or changed in case of board exchange and the repair.

5.3. Changing the serial number (Serial Number)

The proper serial number of LL-S201A is written in case of the board exchange and the
repair.

5.4. Setting the LED back light usage time (Back Light Usage Time)

The usage time of back light is set in case of board exchange or LCD module exchange.

5.5. Backup and restore the White Balance settings (White Balance Settings)

The white balance preset value currently recorded on the set is read, and data is
recorded on PC. The white balance adjustment value of display can be inherited by
exchanging board after recording on PC.

5.6. Factory reset (Factory Reset)

The current preset value is returned to a factory-shipments state.

5.7. Start

aging(Aging)

An aging pattern is displayed and the display is aged.

5.8. Power LED lighting test (Power LED Test)

The Power LED of LL-S201A is blinked on and off.

5.9. Display Test pattern (Test Pattern)

In case of exchange, etc. Display a test pattern on LCD module, and check position
alignment and image quality.

5.10. Touch panel adjustment (TC Adjustment)

In case of exchange touch panel, adjust the touch panel setting.

Advertising