Removing the appliance door, Open the appliance door fully, Fitting the appliance door – Neff U16E74N3GB User Manual

Page 28: Close the appliance door, Cleaning the door panels - top oven ô, Risk of injury, Removing the door panel, Note, Removing the intermediate panel, Release and remove the retainer (figure c)

Advertising
background image

28

Removing the appliance door

1.

Open the appliance door fully.

2.

Open the locking levers on the left and right-hand side fully.

The hinges are secured and cannot snap closed.

3.

Close the appliance door until resistance becomes

noticeable (figure A)

4.

With both hands, grip the door on the left and right-hand side,

close the door a little more and pull it out (figure B).

Fitting the appliance door

1.

Insert the hinges in the left and right-hand holders (figure C).
The notch on both hinges must engage.

2.

Open the appliance door fully.

3.

Close the locking levers on the left and right-hand side fully

(figure D).

The appliance door is secured and can no longer be

removed.

4.

Close the appliance door.

Cleaning the door panels - top oven

ô

To facilitate cleaning, you can remove the door panels from the

appliance door.

:

Risk of injury!

The components inside the appliance door may have sharp
edges. Take care not to cut yourself. Wear protective gloves.

:

Risk of injury!

The appliance must not be used again until the door panels
and appliance door have been correctly fitted.

Removing the door panel
Note:
Before removing, make a note of which way round the

door panel is fitted, so that it is not refitted the wrong way

round.

1.

Unhook the appliance door and lay it on a soft, clean surface

with the front side facing downwards (see section: Removing

and installing the appliance door).

2.

Press in the tabs on the left and right using your fingers

(fig. A).

3.

Carefully lift the door panel slightly and remove it in the

direction of the hinges (fig B).

Removing the intermediate panel
Note:
Before removing, make a note of the position in which

the intermediate panel is fitted, so that you do not refit it the

wrong way round later.

1.

Release and remove the retainer (figure C).

2.

Lift the intermediate panel slightly and take it out (fig D).

Cleaning
Clean the door panels with glass cleaner and a soft cloth.

Caution!
Do not use any sharp or abrasive medium or a glass scraper.

The glass could be damaged.

$

%

&

'

%

$

'

&

Advertising