Neff U16E74N3GB - Manual (Page 32)

32
Replacing the oven light bulb
Replace faulty oven light bulbs.
Spare bulbs can be obtained from the after-sales service or
specialist retailers. Only use these oven light bulbs.
■
For the main oven: E14, 220 - 240 V, 40 W, heat-resistant to
300 °C.
■
For the top oven: E14, 220 - 240 V, 25 W, heat-resistant to
300 °C.
:
Risk of electric shock !
Disconnect the appliance from the power supply. Switch off the
circuit breaker or remove the fuse from the household fuse box.
1. Place a tea towel in the cold cooking compartment to prevent
damage.
2. Turn the glass cover anticlockwise and remove it.
3. Replace the oven light bulb with a bulb of the same type.
4. Screw on the glass cover again.
5. Remove the tea towel and switch on the circuit breaker.
Note: Use rubber gloves if the glass cover cannot be
unscrewed: Or order a special removal tool from the after-sales
service:
■
For the main oven: Order no. 613634
■
For the top oven: Order no. 621743
Changing the halogen bulbs (NeffLight®)
Replace faulty halogen bulbs. You can obtain replacement light
bulbs from the after-sales service or a specialist retailer: G4
fitting, 12 V, 20 W, heat-resistant to 300 °C. Only use these
bulbs.
:
Risk of electric shock !
Disconnect the appliance from the power supply. Switch off the
circuit breaker or remove the fuse from the household fuse box.
:
Risk of burns!
Halogen bulbs become very hot when switched on. When
replacing them, wait until the bulb has cooled down.
Caution!
Clouding in halogen bulbs: Do not touch halogen bulbs with
bare fingers. This causes oils to get onto the glass which are
then burnt on and cloud the glass. Use a clean cloth to change
the bulb.
The halogen bulbs are located on the left- and right-hand sides
under the cooking compartment opening. You can obtain the
necessary tools from our after-sales service.
1. Remove the appliance door (see section: Removing and
refitting the appliance door).
2. Place the tool into the slot and prise off the cover (Fig. A).
3. Use the other tool to pull out the halogen bulb (Fig. B).
4. Change the halogen bulb. Use a clean cloth.
5. Fit the cover.
6. Fit the appliance door.
Note: If the light does not work, check that the bulbs are fitted
correctly.
Changing the door seal
If the door seal is defective, it must be replaced. Replacement
seals for your appliance can be obtained from the after-sales
service.
The door seal is attached in four places (figure A). When
replacing it, disconnect and attach the hooks at all four points
(figure B).
Check again to ensure that the seal is seated correctly in the
corners in particular.
$ %
$ %