Changing and setting menu parametrs, Setting the language, Rinsing – Whirlpool ACE 102 IX User Manual
Page 36: Changing the duration of operation, Setting the clock, Setting automatic start time, Changing and setting menu parametrs , fu
GB34
When the machine is ready for use, you can access the menu in order to change the following parameters or functions:
•
RINSING
•
SETTING THE CLOCK
•
LANGUAGE
•
AUTO START
•
DESCALING
•
COFFEE TEMPERATURE
•
AUTO OFF
•
WATER HARDNESS
•
RESET TO DEFAULT
•
STATISTICS
•
SETTING THE TONE
•
EXIT
Setting the language
To change the display language, proceed as follows:
•
Press the MENU button (B2) to access the menu and then buttons
(B5) and (B6) to select
LANGUAGE.
•
Press OK (B7).
•
Press buttons
(B5) and (B6) until the required language is displayed.
•
Press OK (B7) to confirm.
•
Press the MENU button (B2) to exit the menu.
Rinsing
This function is used to obtain hotter coffee. Proceed as follows:
•
If, when you turn the machine on, you select a small cup of coffee (less than 60ml), use the hot water from the rinse cycle
to pre-heat the cup.
•
If, on the other hand, more than 2/3 minutes have elapsed since the last coffee was made, pre-heat the brewing unit
before making any more coffee. To do so, press the MENU button (B2) to access the menu; the display shows the message
RINSING. Press OK (B7). The display shows 'OK' TO CONFIRM. Press the OK button (B7) again. Let the water run into the
drip tray below or use it to fill (and then empty) the cup to be used for coffee, thus warming it.
Changing the duration of operation
The appliance is factory-set to switch off automatically after 30 minutes of inactivity. To change this time (max 120 min.), proceed
as follows:
•
Press the MENU button (B2) to access the menu and then buttons (B5) and (B6) until the display shows the message
AUTO-OFF.
•
Press OK (B7) to confirm.
•
Press buttons
(B5) and (B6) to set the period of time after which the appliance must switch off (30 minutes, 1 hour, 2 hours).
•
Press OK (B7) to confirm.
•
Press the MENU button (B2) to exit the menu.
Setting the clock
•
Press the MENU button (B2) to access the menu and then buttons
(B5) and (B6) until the display shows the message
ADJUST TIME.
•
Press OK (B7).
•
To set the hours, use buttons
(B5) and (B6) then press OK (B7) to confirm.
•
To set the minutes, use buttons
(B5) and (B6) and then press OK (B7) to confirm.
•
Press the MENU button (B2) to exit the menu.
Setting automatic start time
This function allows you to set the machine to switch on automatically at a time of your choosing.
•
Make sure the appliance clock has been set.
•
Press the MENU button (B2) to access the menu and then buttons
(B5) and (B6) until the display shows the message
AUTO-START.
•
Press OK (B7).
•
The machine displays the message
AUTO-START ENABLE?.
•
Press OK (B7) to confirm.
•
The display shows
AUTO-START 07:30..
•
To set the auto start time, use the buttons
(B5) and (B6) then press OK (B7) to confirm.
•
To set the minutes, use buttons
(B5) and (B6) and then press OK (B7) to confirm.
•
Press OK (B7), the display shows
AUTO-START ENABLED.
CHANGING AND SETTING MENU PARAMETRS