Install the mobile phone hands free seat – Audiovox RVMPKG2 User Manual
Page 6
6
Figure 3
e) Cut off the excess part of the 7-inch strap
(2)
Plug the Mitsumi connector from the Audiovox navigation monitor
cable (part #112C3080) into the receptacle at the top backside of the
mirror/monitor screen. Route the rest of the monitor cable to the
Navigation computer.
(3)
Connect the control box monitor cable to the rearview mirror/monitor
cable. Route the monitor cable behind the headliner of the windshield
then down the A pillar behind the plastic shroud to the under dash
area.
(4)
Connect the 5 wires in the following manner.
a) Red wire - 12 volt constant (positive)
b) Black wire - Chassis ground (negative)
c) Blue wire - 12-volt ignition (12 volt with ignition on)
d) Green wire - Reverse light switch (12 volt when vehicle is in reverse)
e) Yellow wire – Parking brake light switch (Negative when parking
brake on)
WARNING: Observed polarity when connecting the cables. The cable
must not be reversed or modified.
2. Install the mobile phone hands free seat
(1)
Select a suitable and convenient location for the mobile phone. Clean
the selected location