Philips Mando a distancia universal - Manual (Page 5)

Setting up the remote control by learning all key functions
In case the previous method did not work, the three steps mentioned below will guarantee you to setup
the remote control successfully.You can store a function under any of the available keys on the SRU 4002.
For learning key functions to the OK key, refer to ‘Learning the OK key’ hereafter.
1 Keep the OK key and the key you wish to learn pressed simultaneously
for 3 seconds until the LED flashes twice (red) and then remains lit.
– The remote control is now in learning mode.
2 Press the key you wish to copy on the original remote control once.
– Make sure both remote controls are properly aligned.
Place both SRU 4002 and original remote control on a flat surface
(e.g. a table) and aim them head-to-head with about 4 cm in between.
– The LED flashes twice (red), the key has learned the new function and the remote control exits
learning mode. Please test whether the key has learned the function correctly.
3 Repeat above procedure for other keys you wish to learn a new function.
Learning the OK key
Under the OK key you can store a function from your original remote control (learn) or a 1 digit favorite
channel number.
1
Keep keys OK, + VOL (Volume up) and + P (Channel up) pressed
simultaneously for 3 seconds until the LED flashes twice (red) and then
remains lit.
– The remote control is now in learning mode.
2 Press the key you wish to copy on the original remote control.
– The LED flashes twice (red), the key has learned the new function / channel number and the remote
control exits learning mode.
Notes:
–
If, during setup, no keys are pressed for more than 60 seconds, the LED flashes once for a longer period and
the SRU 4002 will automatically exit setup mode and save the latest settings.
– When the SRU 4002 was successfully programmed for STB, the STB keys will become available.
For an overview of the keys and their functions refer to ‘3. Keys and functions’.
Undo setup for STB
• Keep keys + P (Channel up) and (Guide) pressed simultaneously
for 3 seconds until the LED flashes twice (red).
– The remote control will now no longer operate your settop box.
SR U 5 11 0
6 ENGLISH
SRU4002_booklet_v4 27-08-2008 13:20 Pagina 6