Philips Mando a distancia universal - Manual (Page 6)

3. Keys and functions
The illustration on page 3 gives an overview of all keys and their functions.
There are separate keys for operating your TV and operating your settop box (STB).
The STB keys will only become available when the SRU 4002 is programmed to operate a settop box.
For this, refer to ‘Setting the remote control’. When the remote control is not set up for operating a settop
box, all keys will operate your TV.
TV keys, always available
1
y (Standby) ................switches TV on / off.
LED....................................lights up green when a TV command is being sent.
2 s (Mute)......................mutes the TV sound.
3 + VOL –...........................increases / decreases TV volume.
6 E.........................................aspect ratio. Selects between regular (4:3) and wide screen (16:9) TV.
A/V .....................................selects internal / external (Audio / Video) input (TV).
TV keys, available when the SRU 4002 is not programmed for STB
4
Digit 1..............................selects TV channel 1.
5 Cursor keys ................navigate through the TV menu.
OK.......................................confirms menu selection.
6 .......................................opens TV menu.
7 Favorites keys .........- select TV channels 1, 2, 3, 4;
- select favorite TV channels (if stored under the keys).
8 + P – ..................................selects next / previous TV channel.
STB keys, available when the SRU 4002 is programmed for STB
1
y (Standby) ................switches STB on / off (when Dual Standby mode is activated).
LED....................................lights up green when an STB command is being sent.
4 Digit 1..............................selects STB channel 1.
5 Cursor keys ................navigate through the STB / EPG (Electronic Program Guide) menu.
OK.......................................confirms menu selection.
6 .......................................opens Electronic Program Guide.
7 Favorites keys .........- select STB channels 1, 2, 3, 4;
- select favorite STB channels (if stored under the keys).
8 + P – ..................................selects next / previous STB channel.
Note: If, during operation, a key or key combination is pressed for more than 30 seconds or when two keys are
pressed simultaneously, the remote control will stop transmitting.
7 ENGLISH
SRU4002_booklet_v4 27-08-2008 13:20 Pagina 7