Brother HL-5280DW - Manual (Page 63)

Control panel setup
8 - 5
8
1. The factory setting for IP Address may be changed by the APIPA setting.
2. The factory setting for Subnet Mask may be changed by the APIPA setting.
3. PASSPHRASE is used for the WPA-PSK authentication.
4. USER and PASSWORD are used for the LEAP authentication.
WIRED menu options
See WLAN menu options (HL-5280DW only) on page 8-8 for detailed information of the WLAN menu option.
WIRED ENABLE
You can enable and disable the wired network connection by selecting ON or OFF.
TCP/IP
This menu has eight sections: TCP/IP ENABLE, IP ADDRESS=, SUBNET MASK=, GATEWAY=, IP BOOT
TRIES
, IP METHOD, APIPA and IPV6.
■
TCP/IP ENABLE
You can enable and disable the TCP/IP protocol.
■
IP ADDRESS=
This field displays the current IP address of the printer. If you have selected a IP METHOD of STATIC,
enter the IP address that you wish to assign to the printer (check with your network administrator for the
IP address to use). If you have selected a method other than STATIC, the printer will attempt to determine
its IP address using the DHCP or BOOTP protocols. The default IP address of your printer will probably
be incompatible with the IP address numbering scheme of your network. We recommend that you contact
your network administrator for an IP address for the network the unit will be connected on.
■
SUBNET MASK=
This field displays the current subnet mask used by the printer. If you are not using DHCP or BOOTP to
obtain the subnet mask, enter the desired subnet mask. Check with your network administrator for the
subnet mask to use.
■
GATEWAY=
This field displays the current gateway or router address used by the printer. If you are not using DHCP
or BOOTP to obtain the gateway or router address, enter the address you wish to assign. If you do not
have a gateway or router, leave this field blank. Check with your network administrator if you are unsure.
■
IP BOOT TRIES
This field displays how many times the printer attempt to scan the network to obtain the IP address
through the IP METHOD you have set (see IP METHOD on page 8-6). The default setting is 3.
NETWORK
(Continued)
FACTORY
RESET OK? - - -
Level one Level two Level three Level four Options 1 Factory settings