Brother HL-5280DW - Manual (Page 87)

Wireless installation in ad-hoc mode (HL-5280DW only)
10 - 8
10
16
Click Next. The settings will be sent to your printer.
The settings will remain unchanged if you click
Cancel.
Note
If you want to manually enter the IP address settings of your printer, click Change IP Address and enter the
necessary IP address settings for your network. After making your selection, click Next and the Wizard will
search for available wireless networks.
17
To communicate with the configured wireless
device, you must configure your PC to use same
wireless settings. Manually change the wireless
settings on your PC to match the printer’s wireless
settings shown on this screen. Check Checked and
confirmed, and then click Next.
(The settings shown on this screen are for example
only. Your settings will not be the same.)
You have completed the wireless setup. If you chose to install the drivers in step 6,
go to Installing the printer driver on page 10-9.