Beko 19WLP530HID - Manual (Page 28)

-26-
Helpdesk: 0845 600 4911
4.4.6- Automatic Update
If this function is set to On, your television will search for new software through OAD
(Over Air Download) when it is in Stand-by mode and install new software if any are
found. If new software is installed by this method, your television will inform you with a
warning display when it is turned on for the first time after such installation.
4.4.7 Software Update
When a new software is found through OAD (On Air Download) from this menu, it
will be installed automatically. Select Software Update tab and press the OK button.
Your television will start to search for a new software and perform the software install
process if a new software exists.
Note: Software Update tab is not displayed in the Analogue mode.
4.4.8 Decoder Setting
You can set the Decoder Setting tab to On/Off by pressing the Right/Left
movement buttons. When it is set to ON, RF signal will be output from the SCART
output. This option must be set to ON when a Decoder is connected to SCART.
When this option is set to OFF, RF signal will not be output from the SCART output.
This option appears in the menu when the Signal Source is set to SCART. It is not
displayed in the menu in other options.
4.5 Parental Control
In the Parental Control menu, you can
preclude channels that are not appropriate for
children and set age restriction for programs
being broadcasted. Password screen will be
displayed when entering this menu. The menu
will open only when the correct password is
entered. The default password is set as 0000.
You can change the password from the Set
PIN menu as you wish.
PARENTAL CONTROL
Lock System Off
Set PIN
Block Programme
Parental Guidance
Off
Select
Back
Exit
Panel Lock Off
4.5.1 Lock System
When the Lock System feature is set to On , a password is prompted if you want
to enter in the Auto Tuning, Digital Manual Tuning, Analogue Manual Tuning
submenus in the Channel Setup menu and the Program Table menu. These
menus are not accessible unless the correct password is entered.
4.5.2 Set PIN
You can change your Parental Control password from this menu as you wish. To do
this, select Set PIN tab and press OK button. Set PIN menu will be displayed. Once
you enter your new password two consecutive times, your password will be changed.
4.5.3 Block Programme
With the Block Program feature, you can lock the desired channel and prevent
it from being viewed unless the correct password is entered. To do this, select
Block Programme tab from the Parental Control menu by pressing the UP/Down