Beko 19WLP530HID - Manual (Page 34)

-32-
Helpdesk: 0845 600 4911
6.4.1 HDCP
Your TV supports HDCP feature. To use this feature, you must set up a connection to
your TV set’s HDMI video port and select HDMI by pressing the SOURCE button on
your remote control.
NOTE:In HDMI mode; some resolutions are supported when a DVI to HDMI converter
cable from a PC is used. Only 16:9, 4:3, 14:9 (some definitions) are supported as
picture format.
6.4.2 High Definition - HD-READY
Your television can receive high-definition signals (HDTV). You can connect the input
sources (HDTV set-top box or HDTV DVD player) to the (HDMI) socket (digital HDTV
signal). This ensures that you can view digital HDTV programs, even if they are copy-
protected (HDCP High-Definition Copy Protection).
6.5 PC connection
Rear view of the TV
Picture connection
Audio connection
6.5.2 Switching to the PC mode
For your LCD-TV to switch to the monitor (PC) mode, press the AV button on your
remote control. SOURCE menu will be displayed. Select PC by pressing the Up/
Down movement buttons and press the OK button.
6.5.3 PC Access Setting
Enter into the SETUP menu from the Main Menu by pressing the MENU button in the
PC mode. In order to make the necessary settings in this menu, you can select the
headings with the Up/Down buttons on your remote control to perform the following
monitor-related settings.
6.5.4 Auto Position
The most suitable geometric settings in accordance with the entry mode are
configured by this function. For this operation, just select the Autoposition tab and
press OK button.
6.5.5 Horizontal Position:
Horizontal position setting.
6.5.6 Vertical Position:
Vertical position setting.
6.5.1 PC Connection:
Connect the D-Sub15 connector to the PC-IN socket at the back of your television
by using an appropriate cable (not supplied with your television). Again, by using
an appropriate cable, connect the audio output of your PC to the PC AUDIO-IN at
the back of your television to listen to sounds from your PC and you can adjust the
volume level of your source by using VOL+/VOL- buttons.