Belkin PM01110-A User Manual
Page 12
10
G Wireless Router
sections
table of contents
1
2
4
5
6
7
8
9
10
3
KnoWInG yoUR RoUTeR
7� Power Jack
Connect the included 9V DC power supply to this jack�
8� Connections to Computers (Wired Computer Ports) – Gray
Connect your wired (non-wireless) computers to these ports� These
ports are RJ45, 10/100 auto-negotiation, auto-uplinking ports for
standard UTP category 5 or 6 Ethernet cable� The ports are labeled 1
through 4� These ports correspond to the numbered LEDs on the front
of the Router�
9� Connection to Modem (Modem Port) – yellow
This port is for connection to your cable or DSL modem� Use the cable
that was provided with the Router to connect the modem to this port�
Use of a cable other than the cable supplied with the Router may not
work properly�
10� Reset button
The “Reset” button is used in rare cases when the Router may function
improperly� Resetting the Router will restore the Router’s normal
operation while maintaining the programmed settings� You can also
restore the factory default settings by using the “Reset” button� Use
the restore option in instances where you may have forgotten your
custom password�
a� Resetting the Router
Push and release the “Reset” button� The lights on the Router will
momentarily flash� The reset is complete in 60 seconds�
b� Restoring the factory defaults
Press and hold the “Reset” button for at least 10 seconds, then release
it� The lights on the Router will momentarily flash� The restore is
complete in 60 seconds�