B&K AVR101 Series - Manual (Page 36)

CHOOSING A SOURCE
In general, the selected source will appear at the ZONE 1 output, the TAPE output, and the V1 output. To prevent
feedback, TAPE input will not appear at TAPE output and V1 input will not appear at V1 output.
'9' 352 /2*,& DVD Source Composite Video
DVD PCM 2.0 Pro Logic
return control to receiver if desired AUDIO
select desired source - remote now controls source U (SOURCE) step to source desired source
Action From Front Panel From Remote
Note: if your source has separate ON and OFF control like your receiver, pressing the source button will also turn
on that source. If not, you will have to hit POWER while the remote is still set to the desired source.
TAPE MONITOR - If you have an analog three-head cassette or reel-to-reel analog tape recorder you may wish to
use TAPE MONITOR, which allows you to hear exactly what is on the tape as you are recording.
7$3( 352 /2*,& Tape Source S-Video
Analog 2.0 Pro Logic
select TAPE monitor
TAPE will appear on Z1 out (SOURCE) step quickly to TAPE TAPE
wait a few seconds while receiver analyzes
selected source
select desired source or TUNER
source will appear on TAPE and V1 outs (SOURCE) step to source desired source
Action From Front Panel From Remote
Note: The tape monitor loop only allows recording of analog inputs. If you simply choose the source you wish to
tape without then selecting TAPE MONITOR then you can make analog recordings of digital inputs as well as
analog inputs.
TUNER OPERATION
)0 67  &+ 
FM St 96.9 Composite Video
Ch 0 Pro Logic
set FM stereo/mono ↵
(ENTER) SEL or ENTER 6
manually tune up or down to desired frequency
see AM/FM TUNER SETTING for DIRECT / SEEK / TUNE ∧
(UP) or
∨
(DOWN) and then
VOLUME KNOB
TUNE+ or TUNE- 5
change to another channel ∧
(UP) or
∨
(DOWN) CHAN
∧
or CHAN
∨ 4
select AM or FM BAND 3
select TUNER TUNER 2
make sure remote is in AUDIO mode U (SOURCE) step to AM or FM AUDIO 1
Action From Front Panel From Remote
Note: For a few seconds after performing any tuner operation ( TUNER , BAND , CHAN
∧∨
, or TUNE+/- ) you may
directly enter a frequency from the remote control’s numeric keypad. During this time the front panel VOLUME
KNOB also controls frequency and
SEL or ENTER controls stereo/mono selection.
33 p/n 12699 Rev. 9812C