B&K AVR101 Series - Manual (Page 49)

POWER ON TITLES
When you turn your receiver on it displays two lines of text. You can change this text to a personalized message.
Make sure you are in the ADVANCED SYSTEM SETUP menu and the remote is in AUDIO mode.
ADVANCED POWER ON TITLES
1 Power On Line 1
' BK Components '
32:(5 21 /,1( 
change character
previous page
↑ ↓
M E N U
2 Power On Line 2
' Pwrd by Motorola'
32:(5 21 7,7/(6
change position
←→
SEL start editing
ADVANCED SYSTEM SETUP
1 Zone Configuration
2 Power On Titles
move to new line
previous page
↑ ↓
M E N U
select menu page SEL
4 Security Options
3 Control Out
return to ADVANCED SYSTEM SETUP MENU MENU 11
edit Line 2 repeat 4 - 8 repeat 4 - 8 10
move to Power On Line 2 ∧
(UP) or
∨
(DOWN)
­
(PAUSE) or
V
(STOP) 9
finish editing line 1 ↵
(ENTER) SEL or ENTER 8
continue changing characters repeat 5 - 6 repeat 5 - 6 7
move to new character VOLUME KNOB
ˆ
(REW) or
‡
(FF) 6
change blinking character ∧
(UP) or
∨
(DOWN)
­
(PAUSE) or
V
(STOP) 5
activate Line 1 ↵
(ENTER) SEL or ENTER 4
move to Power On Line 1
∧
(UP) or
∨
(DOWN)
­
(PAUSE) or
V
(STOP) 3
activate ADVANCED POWER ON TITLES ↵
(ENTER) SEL or ENTER 2
move to Power On Titles ∧
(UP) or
∨
(DOWN) ­ (PAUSE) or V (STOP) 1
Action From Front Panel From Remote
CONTROL OUT SETUP
Your receiver’s control outputs allow you to control up to 4 external devices such as power amplifiers, projection
screens, etc. The control outputs can be programmed on/off depending on which source is selected. They may
also have global control for all sources for headphone listening or remote repeater functions.
Control Out 1 - Control out 1 is dedicated to zone 1 it can be programmed to be on or off for each source. For
example you may wish to use the control out to pull down a projection screen for your V1 and DVD sources but roll
it up for Tuner and CD. Control out 1 can also be set to HEADPHONE mode. HEADPHONE mode is intended to
control external amplifiers to permit headphone listening without the need for manually turning off your external
amplifiers. HEADPHONE is a global setting for all sources - if you set HEADPHONE for one source it will be set
for all other sources.
46 p/n 12699 Rev. 9812C