B&K AVR101 Series - Manual (Page 45)

ZONE CONFIGURATION
Zone Configuration will allow you to set maximum volume levels for each zone, change remote control ID codes
for each zone and turn off the on-screen display overlays in zone 1. Make sure you are in the ADVANCED
SYSTEM SETUP menu and the remote is in AUDIO mode.
Z1 Setup
Z1 Max Level - Z1 max level allows you to set a maximum volume level for zone 1. This is very useful if you are
using speakers that can’t handle the maximum power output from your receiver or if you simply wish to limit the
volume that can be achieved using normal front panel or remote operation.
WARNING - If you set this level too low, the receiver may appear broken (no sound).
ADVANCED ZONE 1 SETTINGS
2 Z1 Product ID 1
3 Z1 On Screen Enabled
= 0$; /9/ 
move to new line
previous page
↑ ↓
M E N U
4 V1 Output Tape
ADVANCED SYSTEM SETUP
1 Zone 1 Setup
2 Zone 2 Setup
=21(  6(783
move to new line
previous page
↑ ↓
M E N U
select menu page SEL
3 Power On Titles
4 Control Out
1 Z1 Max Level +15 dB
WARNING Connecting a tape
recorder to V1 in LINE mode
can cause speaker damage
adjust parameter ←→
5 Security Options
set desired maximum level VOLUME KNOB
ˆ
(REW) or
‡
(FF) 4
move to Z1 Max Level ∧
(UP) or
∨
(DOWN)
­
(PAUSE) or
V
(STOP) 3
activate ADVANCED ZONE SETTINGS ↵
(ENTER) SEL or ENTER 2
move to Zone Configuration ∧
(UP) or
∨
(DOWN) ­ (PAUSE) or V (STOP) 1
Action From Front Panel From Remote
Z1 Product ID - Each message transmitted from your remote includes a Product Code, identifying the
manufacturer, and a product ID code from 1 to 16. The product ID code allows multiple B&K products to be
controlled from the same remote. Your receiver actually uses two product ID codes - one for zone 1 (normally set
to ID code 1) and the other for zone 2 (normally set to ID code 2). If you have a system with multiple B&K products
then you may wish to set the product ID codes to other values. Note that you cannot set the Z1 product ID to the
same setting as zone 2 or vice versa. If you need to set zone 1 to the current zone 2 setting then set zone 2 to
some other value first. Make sure you are in the ADVANCED ZONE SETTINGS menu and the remote is in AUDIO
mode.
WARNING - if you change the product ID code in the receiver without making the corresponding change
to the remote then the remote will no longer work. Refer to the separate remote manual for details on
changing the remote’s product ID (“device code”).
= 352' ,' 
ADVANCED ZONE 1 SETTINGS
2 Z1 Product ID 1
3 Z1 On Screen Enabled
move to new line
previous page
↑ ↓
M E N U
4 V1 Output Tape
1 Z1 Max Level +15 dB
WARNING Connecting a tape
recorder to V1 in LINE mode
can cause speaker damage
adjust parameter ←→
42 p/n 12699 Rev. 9812C