B&K AVR101 Series - Manual (Page 46)

move back to ADVANCED SYSTEM SETUP MENU MENU 5
set desired product ID VOLUME KNOB ˆ
(REW) or
‡
(FF) 4
move to Zone 1 Zone ID ∧
(UP) or
∨
(DOWN) ­ (PAUSE) or V (STOP) 3
activate Zone 1 Setup
↵
(ENTER) SEL or ENTER 2
move to Zone 1 Setup ∧
(UP) or
∨
(DOWN) ­ (PAUSE) or V (STOP) 1
Action From Front Panel From Remote
Z1 On Screen - During normal operation, when you make a change to a system setting or your receiver detects a
change to the incoming audio or video a message is overlaid along the bottom of your video screen. You can turn
off the overlay display from this menu. This will not affect the on-screen displays when you enter the menu system.
26' HQDEOHG
ADVANCED ZONE 1 SETTINGS
2 Z1 Product ID 1
3 Z1 On Screen Enabled
move to new line
previous page
↑ ↓
M E N U
4 V1 Output Tape
1 Z1 Max Level +15 dB
WARNING Connecting a tape
recorder to V1 in LINE mode
can cause speaker damage
adjust parameter
←→
set Enabled or Disabled VOLUME KNOB
ˆ
(REW) or
‡
(FF) 2
move to Z1 On Screen ∧
(UP) or
∨
(DOWN)
­
(PAUSE) or
V
(STOP) 1
Action From Front Panel From Remote
V1 Output - V1 output is normally set up as a tape loop. The V1 and Z1 output are the current source (V2,
TV-V3, CD, DVD, etc.) except when the current selection is V1. When V1 is selected as the source, the Z1 output
is V1 and the V1 output is off. This prevents feedback when the V1 inputs and outputs are connected to a tape
deck or VCR. Feedback can cause high frequency oscillations which may damage your speakers. If you don’t
connect a tape deck to the V1 input and output you can use the V1 output as an additional line out. In this mode
V1 output is always the selected input including V1. Note: The Tape input and output is always set up as a tape
monitor for zone 1.
Y RXWSXW WDSH
ADVANCED ZONE 1 SETTINGS
2 Z1 Product ID 1
3 Z1 On Screen Enabled
move to new line
previous page
↑ ↓
M E N U
4 V1 Output Tape
1 Z1 Max Level +15 dB
WARNING Connecting a tape
recorder to V1 in LINE mode
can cause speaker damage
adjust parameter
←→
move back to ADVANCED SYSTEM SETUP MENU MENU 3
select either Tape or Line VOLUME KNOB ˆ
(REW) or
‡
(FF) 2
move to V1 Output ∧
(UP) or
∨
(DOWN) ­ (PAUSE) or V (STOP) 1
Action From Front Panel From Remote
43 p/n 12699 Rev. 9812C