Beltronics E936CS - Manual (Page 6)

sample alerts) press
CTY
or
AUD
to move forward or backward
through the alerts. During sws ™ sample alerts press
CTY
to
move forward in the sws ™ message list. “MSG 1”will appear
initially in the display confirming your selecion. Pressing the
AUD
button allows you to listen to the sws ™ message while
viewing it in the display. Press the
CTY
button again to step to
the next message; press the
AUD
button to review, and so on.
This allows you to review all 60 messages.
To exit Tutorial Mode, press the
P
/
V
button and your unit
will be
ON
and ready to receive signals.
Memory Retention of Feature Selections
Any time EXPRESS 936 is turned
OFF
or unplugged from the
cigarette lighter socket, all feature settings are retained in the
unit’s memory. Memory retention eliminates the need to reset
your preferred feature settings each time your unit is turned
OFF
and then back
ON
.
Adjusting the Audio Level
Once your unit has completed the power up test sequence, the
audio level can be adjusted by holding the
P
/
V
button down.
As you hear the audio level change, the display will provide a
visual reference of the audio level. To reverse the direction in
which the audio level increases/decreases, briefly release, then
hold down the
P
/
V
button again.
DRK (Dim/Dark) Button
The
DRK
button allows selection of a dim or dark setting for the
display. To engage dim mode, press the
DRK
button once. A single
“beep” coupled with the brief illumination of “DIM” on the display
confirms your selection. To completely cancel the illumination of
the display during an alert, press
DRK
a second time. A single
“beep” coupled with the brief illumination of “DARK” in the
display confirms your selection. While in dark mode, you will
notice an “H” (highway mode) or “C” (city mode) remains dim to
confirm your unit is receiving power. To return to a full bright
setting, press the
DRK
button a third time; two “beeps” confirm
this selection. Use of the
DRK
button does not affect audio alerts.
Important—if you press the the DRK button and do not receive
audible confirmation, the audio level has been set too low.
6