Beltronics E936CS - Manual (Page 9)

Reset to Factory Settings
You can reset your unit to factory settings for volume,
DRK
,
AUD
,
CTY
and Selectable Features. With the unit
OFF
, press and hold
CTY
button, then press
AUD
and
P
/
V
buttons simultaneously. The
display will briefly show “RESET” and provide two “beeps”. Your
unit is now reset to its original factory settings and ready for
operation.
Safety Warning System ® , vG-2 Guard ® Alert, sws ™ Digital
Voice Messages and Radar/Laser Digital Voice prompts are
features which may be selected
ON
or
OFF
, depending upon
your preference.
Safety Warning System ® (sws ™ )
When
ON
, unit will provide an alarm and text message when
signals from sws ™ transmitters are detected. Factory setting
is
ON
.
VG
-2 Guard ® Alert
When activated, unit will detect signals from Interceptor
VG
-2
transmitters. Factory setting is
OFF
.
Note-engage VG -2 Guard ® only, in areas known to use the
Interceptor
VG
-2.
Safety Warning System ® (sws ™ ) with Digital Voice Messages
When “SWSvoice” is selected, unit will provide Digital Voice
announcements when sws
TM transmitters are detected. Factory
setting is “SWSvoice”. When “SWSclick” is selected, Digital
Voice is replaced by “tone/clicking” only.
Radar/Laser Digital Voice prompts
When “VOICEon” is selected, unit will provide Digital Voice
prompts followed by “beeps” when X/K/Ka and Laser signals
are detected. Factory setting is
ON
. When “VOICEoff” is
selected unit will sound unique audio tones only.
Entering Selectable Features Mode
1. With the unit
OFF
, press and hold
CTY
button, then press the
P
/
V
button. The word “FEATURES” will appear in the
SELECTABLE FEATURES
9