Connecting power to your system, Setting up the personal™ music center – Bose 50 User Manual

Page 19

Advertising
background image

AM189854_05_V.PDF

October 17, 2001

17

Setting Up

Connecting power to your system

Plug the Acoustimass

®

module power cord into an AC power (mains) outlet. Then plug in the

multi-room interface power pack.

Note:

Your speakers will not operate unless you complete all cable and power connections

before turning on the system.

CAUTION:

Be sure the three shipping screws on the bottom of the CD changer have been

removed before turning on the system.

Setting up the Personal™ music center

Set up the Personal music center after the rest of the system is connected and plugged in.

Note:

When batteries are first installed in the music center, it sets up a radio-frequency link

with the closest multi-room interface.

1. Hold the music center within a few feet of the multi-room interface.

2. Slide open the battery compartment on the back of the music center (Figure 17).

3. Insert 4 AAA or IEC-R03 1.5V batteries, or the equivalent, as shown. Match the + and –

symbols on the batteries with the + and – markings inside the compartment.

4. Slide the battery compartment cover back into place.

5. Turn the music center over and touch the screen to wake it up if it appears blank. Press

ON/OFF, FM, or any other source button to turn the system on.

If the music center continuously displays “NO RESPONSE,” you need to try to establish
its link with the multi-room interface again. Hold the music center close to the multi-room
interface. Press and hold MUTE for about 5 seconds until you hear a beep and then release.
After about 10 seconds, the music center should beep twice to confirm that the link is
established.

Figure 17

Installing batteries and waking
up the display for the first time

Note:

Replace the batteries when the LOW BATTERY message first appears. See “Replac-

ing batteries” on page 44. Alkaline batteries are recommended.

Battery compartment cover

4 AAA

batteries

b. Turn over and wake up display

a. Install batteries

Advertising