Bose 50 - Manual (Page 49)

AM189854_05_V.pdf October 17, 2001 47
Problem What to do
CD does not play • Check to see if the PLAY button symbol in the display is flashing.
• Make sure the magazine is properly inserted.
• Check to see if there is a disc in the magazine, label-side up. Display shows a flashing
number for a disc that is label-side down or cannot be read. Display shows noCd if no
discs are loaded.
• Eject the magazine and try loading the CD again.
• There may be dirt or dust on the CD. Clean the CD.
• The disc may be defective. Try another disc.
• The CD changer cannot play a DVD disc.
• If the CD changer is not properly connected the display shows Plug in cd.
• A display message Err indicates a mechanical error. Call Bose
® Customer Service (see
inside back cover for listings).
Radio does not work • Make sure antennas are connected properly.
• Position the AM antenna as far away from the multi-room interface as possible, at least 20
inches away.
• Adjust antenna position to improve reception. Use SIGNAL LEVELS menu to determine
best reception. You may be in an area of weak signal coverage.
• Make sure the AM antenna is upright.
• Move antennas farther from TV or other electronic equipment.
FM sound is distorted • Adjust antenna position to reduce interference.
Sound is distorted • Make sure speaker cables are not damaged and the connections are secure.
• Reduce the output level from any external components connected to the CD changer.
No tape, CD, VCR, • Check the connections.
or TV sound • Make sure the component is turned on.
• Refer to the component owner’s manual.
A display button does not • Calibrate the display screen. When you can only initiate a function by pressing the button
activate its function when too far off center, then a display screen calibration may be necessary. Calibrating the
pressed on center display screen aligns the button icon with the appropriate area of the screen.
1. Press and hold the source display area (top center) until CAL appears.
2. Press the SOURCE button as close to its center as possible. The KEYPAD button
appears.
3. Press the KEYPAD button as close to its center as possible. A small round button
appears at the bottom right of the screen.
4. Press the small round button as close to its center as possible to exit the calibration
function with a newly calibrated screen.
• Contact Customer Service for assistance.
Warranty period
The Bose ® Lifestyle ® 50 system is covered by a limited 1-year transferable warranty. Details of
the warranty are provided on the warranty card that came with your system. Please fill out the
information section on the card and mail it to Bose.
Customer Service
For additional help in solving problems, contact Bose Customer Service. See the inside back
cover for Bose Customer Service offices and phone numbers.
Maintaining Your Lifestyle ® 50 System