Philips Do-It-Yourself clipper Se tondre les cheveux soi-même - Manual (Page 7)

- This appliance is only intended for clipping human scalp hair. Do not
use it for any other purpose.
- If the appliance is subjected to a major change in temperature, pressure
or humidity, let the appliance acclimatise for 30 minutes before you use
it.
Compliance with standards
- The appliance complies with the internationally approved IEC safety
regulations and can be safely cleaned under the tap.
- This Philips appliance complies with all standards regarding
electromagnetic fields (EMF). If handled properly and according to the
instructions in this user manual, the appliance is safe to use based on
scientific evidence available today.
Charging
Charge the appliance for at least 1 hour before you use it for the first time
or after a long period of non-use.
When the appliance is fully charged, it has a cordless clipping time of up to
1 hour.
When the charging light flashes orange, the battery is running low (approx.
10 minutes of operating time left) and you need to charge the appliance.
1 Make sure the appliance is switched off.
2 Insert the appliance plug into the appliance and insert the adapter
into the wall socket.
, The charging light starts to flash white to indicate that the appliance
is charging.
, When the battery is fully charged, the charging light lights up white
continuously.
, After approx. 30 minutes the charging light goes out to save energy.
optimising the lifetime of the rechargeable battery
Discharge the rechargeable battery completely twice a year by letting the
motor run until it stops. Then fully recharge the battery.
Corded clipping
1 Switch off the appliance.
2 Connect the appliance to the mains and wait a few seconds before
you switch it on.
Note: If the battery is completely empty, wait a few minutes before you switch
on the appliance.
English 7