Bissell 9500 - Manual (Page 10)

10
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
ATTENTION:
Some Berber carpets have a
tendency to fuzz with wear.
Repeated strokes in the same
area with an ordinary vacuum
or deep cleaner may aggravate
this condition. Please see Stain
Removal instructions on page 14.
O
peration
Before you clean (continued)
5. Pretreating (optional)
Pretreating is recommended to improve cleaning
effectiveness for heavily soiled carpet in high
traffic areas such as entryways and hallways.
Option A: BISSELL Tough Stain PreTreat
A. Spray the BISSELL Tough Stain Pre-treat
formula onto heavy traffic areas, soiled
areas, or stains.
B. Allow to penetrate for at least 3 minutes.
C. Clean as normal, using the BISSELL
ProHeat 2X machine on the high traffic
setting, following the instructions below.
Option B: CleanShot™
A. Set Custom Clean for the desired setting.
B. Press the CleanShot button and aim the
focused stream onto the stain. Allow the
formula to soak in for 30 seconds.
C. Run the machine over the stain to extract.
Repeat as needed until the stain is gone.
D. Rinse if desired.
Carpet cleaning
1. Fill the 2-in-1 Water Tank. Remove the tank
from the base of the machine by lifting up the
tank carry handle. Carry like a bucket to the sink.
1a. Unlatch the top of the tank from the bottom
by lifting up on the tank latch which is located
on the back of the tank.
1b. Remove the top of the tank by lifting up on
the handle.
Note how the lip on the top tank separates
from the groove in the bottom tank. This
placement is important when putting the
tank back together
1c. Fill the heavy duty bladder with clean hot
tap water. *Do not boil or microwave water
as it can destroy the bladder.
1d. Leaving the filled bottom of the tank on a
flat surface, only maneuver the top of the
tank. To attach the top part of the tank to the
bottom, carefully hook the lip on the top tank
into the groove on the bottom tank.
1e. Fasten tanks together by securing the latch
in the back.
Note: Remember to secure the tank latch in
the back and test to make sure it is secure
before picking up the tank.
1. 1a.
1b.
Lip
Groove
(underside of
bottom tank)
1c.
1d.
1e.
ug120-4080_7350_908.indd 10 10/14/08 1:24:47 PM