Bissell 9500 - Manual (Page 11)

11
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
O
peration
Carpet cleaning (continued)
2. Remove formula tank from back of machine.
2a. Fill the formula tank by first unscrewing the
cap and insert. Always use genuine BISSELL
formulas to maximize cleaning and for the
safety of your machine. Fill formula up to the
line and replace the cap and insert. Place
formula tank into the slot in the back of the
machine for a snug fit.
2b. If using the BISSELL 3X Concentrated Fiber
Cleansing Formula: Add 3 capfuls of 3X
Concentrated Fiber Cleansing formula to the
formula tank, and then fill with hot water to
the line.
3. Set Custom Clean Dial. Simply choose one
of the 4 settings (heavy traffic, normal clean,
light clean, or water rinse) and the ProHeat
2X will adjust the right amount of cleaning
solution to mix with the heated water to fit
your cleaning need.
4. Set ReadyTools Dial to the floor cleaning setting.
5. Plug into a proper outlet and turn the power
and heater switches to the ON ( I ) position. Allow
1 minute for the built-in heater to warm-up before
cleaning. The ProHeat 2X will be fully warmed and
will provide optimal performance after a minute of
continuous heated cleaning.
6. Cleaning Strokes. While pressing the trigger,
make one slow forward wet pass and another
one back. Let the built-in heater, formula, and
DirtLifter PowerBrushes do the work for you.
Caution: Do not overwet. Take care not to run
over loose objects or edges of area rugs. Stalling
brush may result in premature belt failure.
Note: Your machine is equipped with a
circuit breaker that will automatically shut
off the brush if a large or loose object is
caught in the brush roll. If that happens, be
sure to unplug your machine, remove the
foreign object, and then plug the machine
back in to reset the circuit breaker.
Release the trigger and make one slow
forward and backward pass over the same
area to remove any residual dirty water and
aid in drying. Repeat cleaning passes until
solution being pulled up appears clean.
Continue passes without pressing the trigger
until you can’t see any more water
being pulled up.
FLOOR
CLEANING
2. 2a.
4.
RIN
SE
W AT ER
3.
Power Switch Heater Switch Power Switch Power Switch
5.
ug120-4080_7350_908.indd 11 10/14/08 1:24:48 PM