Bissell 9500 - Manual (Page 19)

M
aintenance and care
Brush removal and large belt replacement
Brushes can be removed for cleaning or
replacement as needed.
1. Follow small belt removal Instructions on
page 17.
2. Remove brush rolls by pulling them off of
the metal rods.
3. Place cleaned or new brush rolls back onto the
rods. Make sure one washer is on each end of
the rollers prior to sliding onto the rod. Be sure
to let the rod slide through the bushing to
insure proper fit.
4. Re-attach the long belt on the bottom to the
cogs of the small roller brushes.
5. Place small belt over back roller and
metal cog.
6. Place pivot arm in place and screw in place
using the silver screw.
7. Re-attach clear end cap by tightening with
the (2) black screws.
8. Return front nozzle to front of unit, be
latching from underneath and then securing
with a screw.
If you have any questions or are having
trouble installing or replacing your belt(s) or
brushes, please call BISSELL Consumer
Services at 1-800-237-7691.
WARNING:
To reduce the risk of fire,
electric shock or injury,
unplug from the outlet
before servicing.
19
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
2. 3.
4. 5.
6. 7.
8.
T
roubleshooting
Built-in heater ready light does not illuminate
Possible Cause Remedies
1. The heater switch is not turned ON ( I ). 1. Turn the heater switch ON ( I ).
2. The power switch is not turned ON ( I ). 2. Both switches must be ON ( I ) to
activate the heater ready light.
Reduce Spray or No Spray
Possible Cause Remedies
1. Water tank may be empty. 1. Fill heavy duty bladder with hot tap water.
2. Formula tank may be empty. 2. Fill formula tank with BISSELL Fiber
Cleansing Formula for cleaning.
ug120-4080_7350_908.indd 19 10/14/08 1:24:57 PM