Barco R9002139 - Manual (Page 17)

Controlling
4-3 5975039 BARCOVISION 508 100698
To continue using the RCU, it is necessary to enter an address with
the digit buttons (address between 0 and 9). For example : if the
Address key displays projector address 003, the press "3" digit
button on the RCU to set the RCU's address to match the projector's
address. Do not press digit 003. This will address the remote to '0'
and control all projectors in the room.
How to program an address into the RCU?
Press the ADDRESS key (recessed key on the RCU) with a pencil
and enter the address with the digit buttons. That address can be
any digit between 0 and 9.
Input selection
Source No Projector input Press button
1 Comp. Video 1
2 S-Video 2
3 RGsB 4
3 RGBS 5
3 YsUV 6
3 YUVS 7
Two possible ways of selecting an input :
a) With the digit buttons on the RCU, it is possible to select one of the
seven input sources, Video, S-Video, TV-Video, RGsB or RGBS,
YsUV and YUV.
b) With the local keypad :
press first the ADJUST key to display the General access menu.
Use the control disc to highlight the desired source number. Push the
control disc up or down to move the cursor up and down, push the
control disc to the left or to the right to move the cursor to the left and
to the right.
Press ENTER to confirm your selection.
When a valid and available source is selected, there will be informa-
tion displayed on the screen about that source. This information
includes :
- Source number
- Horizontal frequency
- Vertical frequency
When the entry is a non valid source number, a warning appears on
the screen : 'input not available'.
When a valid source number is selected, the projector will display this
source or it will wait on the selected source number until the source
becomes available. A message 'source not available' will be
displayed for a short time.
GENERAL ACCESS
Select with ,
or
then <ENTER>.
<EXIT> to return
SHARPNESS
TINT
COLOR
BRIGHTNESS
CONTRAST
5 6 7
3 4
1 2
Enter ADJUST
$'-867
67$1'%< (17(5
(;,7
Source 2
Fh = 15,6 kHz
Fv = 50 Hz
Warning
input not
available
Warning
source not
available