Barco R9002139 - Manual (Page 36)

Service Mode
7-3 5975039 BARCOVISION 508 120198
Total Run Time
Highlight 'Total Run Time' with the control disc and press ENTER to
display the amount of time the projector has played since its first start
up at the factory.
Note : all projectors leave the factory after a burn-in period of
approximately 100 hours.
Change password
This item is password protected.
Highlight 'Change Password' with the control disc and press ENTER.
ENTER gives the selected item.
EXIT returns to the Service mode menu.
ADJUST returns to the Operational mode.
Select with or
then <ENTER>
<EXIT> to return.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
ENTER will display the selected item.
EXIT will return to the Path Selection main menu.
ADJUST will return to the Operational mode.
The current password is displayed. The new password must
consist of 4 digits between 0 and 9. Push the control disc to the left
or to the right to select the digits to be changed. Use the numeric keys
to enter the new digits.
Press ENTER to save the new password. Before saving the new
password, a confirmation screen will be displayed.
Press EXIT to return to the Projector Set-up menu without saving the
new password.
When the displayed password is correct, press ENTER to save.
If not correct, press EXIT to cancel the saving.
Select with or
then <ENTER>
<EXIT> to return.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
Use and to select,
and reprogram
with numeric keys.
<ENTER> to confirm
<EXIT> to return
PASSWORD
Enter new password :
0 0 0 0
Password will be
reprogrammed as xxxx
<ENTER> to confirm
<EXIT> to cancel
CHANGE PASSWORD
ENTER saves the entered password.
EXIT returns without saving.
Change Projector Address
Every projector requires an individual address between O and 255.
This address can be software installed.
To change that address, push the control disc up or down to highlight
'Change Porjector Address' and press ENTER. The Change Projector
Address menu will be displayed and the actual address will be filled
in.
Select with or
then <ENTER>
<EXIT> to return.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
ENTER displays the 'Change Projector Address' menu.
EXIT returns to the Service mode main menu.
The first digit is highlighted. Select the individual digits by pushing the
control disc to the right or to the left. Reprogram with the digit keys
on the RCU.
Press ENTER to confirm.
Press EXIT to return to the projector set up menu.
<ENTER> to confirm
<EXIT> to return.
PROJECTOR ADDRESS
Enter new projector
address :
0 0 0
Use and to select,
and reprogram
with numeric keys.
Highest address is 255