Barco R9002139 - Manual (Page 43)

Options
8-1 5975039 BARCOVISION 508 100698
IR Receiver 800
This infrared receiver unit makes it possible to control the projector
from another room.
There is a communication line with cable between the IR receiver and
the projector or the RCVDS05. The control information from the RCU
can now be sent to this IR receiver.
The IR receiver 800 displays the selected source on a 7-segment
display.
Order number : R9827515
Hardwired RCU.
The control signals from the RCU can be sent to the projector via a
wired connection.
OPTIONS
shield
conductor
Preparing your remote cable :
Use a shielded cable with a maximum length of 100 m and two mini-
jack 3.5 mm connectors (order number : R3131991).
- Peel back the vinyl covering of the cable on both sides and twist the
wire core.
- Solder a jack plug as shown in drawing above to each end of the
cable.
shield = ground
conductor = data information
When the cable is ready, plug one side in the remote control and the
other side in the connector on the rear of the projector labelled
‘remote’.
RCVDS 05 Source Selector
An optional RCVDS05 makes it possible to connect up to 20 sources
to the projector. When RCVDS's are linked via the expansion module,
even 90 inputs can be connected to the projector.
The selected source number will be displayed on a 2 digit display and
the selected input module will be indicated with a LED on the rear.
Order Numbers RCVDS 05: 110V: 9827888
9827889
220V: 9827880
9827881
VS05 Switcher
The VS05 is a versatile Video and HDTV source selector for all
BARCO's digitally controlled large screen projectors. It offers the
possibility to connect and switch up to 5 different Video sources, 3
different S-Video sources and 1 RGB Analog source to a BARCO
projector. In addition, the audio signal proper to the source, can be
switched to an audio amplifier.
Order Numbers: 110V: 9827890
220V: 9827899
8
Adapter and communication cables
BARCO provides several cables to connect peripheral equipment to
the projector.
a. D9-D9 communication cable
- To connect an IBM PC (or compatible) to the projector.
- To connect a RCVDS05 to the projector.
- To connect a IR receiver to the RCVDS05 to the projector.
- To be used as extension cable for all other adapter cables.
Available length :5 m (16ft), order number R982770; 15 m(50ft), order
number R9827560; and 30 m (100ft), order number R9827570
b. Din Mini8-D9 adapter cable.
- To connect a Macintosh computer to the RETROGRAPHICS 808s.
Available length : 1 m (3,2 ft), order number R9827640.
c. D25-D9 adapter cable
- To connect a workstation to the RETROGRAPHICS 808s.
Available length : 1 m (3,2 ft), order number R9827630
d. 5 BNC to 5 BNC cable
- To connect an analog source to the BNC input of the projector
Available lenght : 60 cm, order number R9828260
150 cm, order number R9828261
5 m, order number R9828262
15 m, order number R9828263
Ceiling mount CM50
This suspension system enables to mount any projector from the
BARCO 700 series to the ceiling without using any mechanical
interface, and to adapt the projector perfectly to the local mounting
requirements.
Order number CM50 with pulley : R9827990
Order number CM50 without pulley : R9827991.