Basic operation, Programming, Select desired temperature – Bryant PROGRAMMABLE DIGITAL TERMOSTAT OM 17-101 User Manual
Page 3: Override, Page 3, Occupied and unoccupied periods
Page 3
Basic Operation
Programming
Occupied and Unoccupied Periods
ProgramOn
Pm
Su
unoccupied
Pm
ProgramOn
Su
Override
occupied 1
:
Stop
:
:
HEAT
COOL
HEAT
COOL
Pressing the up/down buttons in Auto mode will adjust
both
the heat
and cool set point temperatures simultaneously.
Pressing the up/down buttons in Heat
or
Cool modes will adjust only
the heat
or
cool set point temperature.
Select Desired Temperature
During programmed, unoccupied
periods a press of the Override
button will force the thermostat into
Occupied 1 comfort settings,
temporarily.
With each successive push of the
Override button, the override timer
will add 30 minutes, until the maxi-
mum of 4 hours is reached. Then
the next press will zero out the over-
ride timer, returning to unoccupied if
there are no further button presses.
When in Override, the Override icon
and the Occupied 1 icon appear on
the display.
The time of day clock alternates with
the time remaining in override.
During Override, the set point tem-
peratures are adjustable, provided
the keypad is not locked.
Override
AUTO
Pm
M
:
HEAT
COOL
buttons.
In any mode, adjust the
desired Set Point Temperature
with
occupied
occupied 1
occupied 1
unoccupied
1
COOL
COOL
COOL
HEAT
Select the maximum number
of occupied periods to be
used on any one day.
Typically 1.
Adjust the cooling
set point for occupied 1.
(35 to 99 F)
(1,2 or 3)
Adjust the heating
set point for occupied 1.
(35 to 99 F)
Adjust the cooling
set point for unoccupied
periods.
(35 to 99 F)
unoccupied
M
occupied 1
Start
occupied 1
Stop
Pm
M
occupied 1
ON
M
occupied 1
HEAT
COOL
Am
M
:
:
Adjust the heating
set point for unoccupied
periods.
Select the day for
Occupied 1.
Select Occupied 1 to run
on this day (On), or not to
run this day (Off).
Adjust the start time
for occupied 1.
Adjust the stop time
for occupied 1.
(35 to 99 F)
Tu
occupied 1
Start
Am
Tu
occupied 1
Stop
Pm
Tu
occupied 1
Tu
:
:
The copy command becomes available after the maxi-
mum number of occupied periods are programmed in a
day. This example uses 1 as the maximum occupied
periods ever programmed in one day.
Selecting Yes, then pressing mode will copy the previous day’s program and
then will ask the same copy question again. If yes is selected each time, this
routine will repeat until Saturday is copied to Sunday. After Saturday is
copied to Sunday, the copy command is unavailable.