Bosch D1260 User Manual
Page 69
D1260/D1260B | Owner's Manual | Part IV: Multi-Area Use - View Point Status
Bosch Security Systems | 9/04 | 50410D
69
4.
The display will change to show on the top line the
area name and the current status on the second
line.
Pressing the
Next>
soft key will change the
display to the next area and remain for 20 seconds
or until the
Next>
soft key is pressed for the next
area. If the time has elapsed, the display returns to
idle text.
Pressing the
<Previous
soft key will change the
display to the previous area.
5.
Press the
<Exit
soft key to return to idle text.
View Point Status
Use this function to identify the number or location of
each point in an area, and to show the current
condition of any point you select.
1.
Ensure your keypad shows idle disarmed text.
2.
Press the
Menu>
key to enter the Command
Menu.
3.
Press
Next>
repeatedly until you reach the
VIEW
PT STATUS ?>
prompt.
Press the adjacent soft key.
4.
In this example, Area 1 is the area and there are
eight points assigned to area 1 that can be viewed.
Press the
Next>
soft key to view the first point in
the area; press the
<Previous
soft key to view the
last point in the area. You may press the
<Exit
soft
key at any time to exit this function.
5.
The top line indicates that you are still in View
Point Status mode. The second line will display the
point text.
Pressing the
Next>
soft key takes you to the next
point in the area whereas the
<Previous
soft key
will take you to the previous point in the area.
To view the status of a point, press the
Status>
soft
key.
6.
After pressing the
Status>
key, the command
center will display the following information:
Refer to Table 5 for more information.
Table 5: Screen Area Definitions
Line
#
Area Name
Definition
Area #
This may display numbers 1 to 8.
1
Pt #
This may display point numbers 1
to 127 and 129 to 247,
Normal
indicates that the point
is not in the faulted
state.
Open
indicates that the point
is in an open state.
Short
indicates that the point
is in a shorted state.
2 (Point
State), HW
Missing
indicates that the point
is missing.