Bosch D1260 - Manual (Page 95)

D1260/D1260B | Owner's Manual | Appendix - Standard Displays
Bosch Security Systems | 9/04 | 50410D 95
Standard Displays
Your command center uses standard and custom
displays to show the status of the security system. Many
standard displays are described below. Your system
may not use all of them. Descriptions of your custom
text follow.
System Command
Displays when you press the COMMAND key. The
system is waiting for you to enter a one or two digit
number to complete the command.
Enter Passcode to Disarm
When the system is turned on, entering through a
delay door starts entry delay time.
The command center emits a tweedle tone and
alternates between
Enter Passcode and press the
ENTER key to disarm and AREA 1 WAREHOUSE
is in entry delay . (AREA 1 WAREHOUSE is used as
an example.)
You must turn off the system before entry delay time
expires to avoid creating an alarm event.
Exit Now
Arming your system starts exit delay time. The
command center emits a repeating beep tone and
displays
AREA 1 WARE HOUSE is now arming for
3 seconds and then displays Exit Now! .
No Authority
The system does not recognize the passcode entered.
Perimeter Delay
Indicates that the perimeter is armed (turned on) with
entry/exit delay time. (See Turning On the System With
Delays
)
Perimeter Instant
Indicates that the perimeter is armed (turned on)
without entry/exit delay time. (See Turning On the
System Without Delays
).
First Disarm – Area must be disarmed first
Indicates that the function requested can only be
performed when the area is disarmed. Disarm the area
to perform the function.