Brother HL 4150CDN - Manual (Page 30)

Printing Methods
24
1
Printing data directly from the USB flash memory drive
1
If you print data from the USB flash memory drive with Secure Function Lock 2.0 enabled, see Chapter 6 of
the Network User's Guide for more information about Secure Function Lock 2.0.
a
Connect your USB flash memory drive to the USB Direct Interface (1) on the front of the machine.
b
<Secure Function Lock enabled> Confirm the LCD shows the following message. Press OK.
Function Lock
Press OK and sel
<Secure Function Lock disabled> Confirm the LCD shows the following message. Then go to Step e.
Checking Device
Note
• When the machine is in the Deep Sleep mode, the LCD does not show any information even if you connect
a USB flash memory to the USB direct interface connector. Press Go to wake up the machine, and the
LCD will show the Direct Print menu.
• If the USB flash memory drive provides a high speed access, it make be difficult to confirm the
Checking Device
message, which may appear for only a few seconds. The time taken to show
Checking Device
on the LCD depends on the communication speed between the machine and the
USB flash memory device and the amount of content in the USB memory.
c Press + or - to choose ID. Press OK. If you chose Public, go to Step e.
Select ID
Public
d
Enter the four-digit password. Press OK.
Select ID
PIN:XXXX
Note
If your ID has been restricted, the following messages may appear on the LCD.
Message Meaning
Mono Print Only
Printing color documents is restricted. You can only print monochrome documents.
Remaining Pages
The number of pages you are allowed to print is restricted. The second line of the LCD
shows the number of remaining pages you can print.
1