Philips 4-Channel Sound Card - Manual (Page 27)

Windows NT

Installation
Installation of the drivers for your Philips Seismic Edge PCI Audio in
a Windows NT

environment are as follows (note: you must have
the appropriate privileges in order to install the drivers):
•• Boot the system to the Windows NT

desktop.
•• Go to D:\ NT40\ English\ and double click on Setup.exe (D: repre-
sents your CD-ROM drive.)
•• Wait a couple of minutes while the data transfers. Once it finishes
the Philips Seismic Edge Settings window will appear. Click OK on
the settings page and then when the ''System Settings Change''
page comes up and prompts you to restart, click the ''Restart
Computer Now'' button.
That's it! Once the system reboots to Windows NT

your Philips
Seismic Edge

should be fully functional as will be indicated by the
Windows

Startup sound.
Yamaha SoftSynthesizer Installation for Windows NT

Follow these steps to install the Yamaha SoftSynthesizer from your
install CD:
1) Insert your install CD into your CD drive
2) Go to D:\S-yxg50\Nt40\Disk1\ (D: represents your CD-ROM
drive)
3) Double Click on Setup.exe
4) Follow the on-screen instructions for installation. The required
serial number is located on the Yamaha Corporation Certificate of
Authenticity included with your documentation.
Siren XPress Installation for Windows NT

Follow these steps to install the Siren XPress. This application
allows you to play and organize music.
Philips Seismic Edge
 
27
Philips 4-ch-091100-11-40.qxd 2000/9/11 AM 11:39 Page 27