Philips 42PFL7682D-12 - Manual (Page 51)

47
English
Note
• Cables are often colour coded. Connect
red to red, white to white, etc.;
• The labels for the component video
sockets may differ depending on the DVD
player connected. Although the
abbreviations may vary, the letters B and
R stand for the blue and red component
signals, respectively, and Y indicates the
luminance signal. Refer to the DVD
player’s instructions for use for
definitions and connection details;
• To get an optimal viewing, it is advised to
switch your equipment to the highest
possible supported display modes.
Warning
If you notice scrolling images,
wrong colours or no colour, no picture, or
even combinations of these on your screen,
verify if the connections are done in the
correct way and if the resolution and the
signal standard of the connected equipment
are set in the right way. See the user manual
for your equipment.
32.7 Connect a PC
Note
• Only digital output of the PC can be
connected via DVI to HDMI cable.
VGA connection is not supported.
• Before connecting your PC to the TV,
select your PC monitor settings to a
refresh frequency of 60 Hz.
PC equipped with a DVI connector
1 Use a DVI to HDMI cable to connect
to one of the HDMI connectors of your
TV 1 .
2 Connect the audio cable to the PC’s
AUDIO jack and to the L/R AUDIO
jacks of TV
EXT3
2 .
3 Press the key on the remote
control to display Source list.
4 Press the ï key to select HDMI 1 or
HDMI 2
and press the Æ/ key
to confirm selection.
Supported PC resolutions
640 x 480, 60 Hz 800 x 600, 75 Hz
640 x 480, 72 Hz 800 x 600, 85 Hz
640 x 480, 75 Hz 1024 x 768, 60 Hz
640 x 480, 85 Hz 1024 x 768, 70 Hz
800 x 600, 60 Hz 1024 x 768, 75 Hz
800 x 600, 72 Hz 1024 x 768, 85 Hz
PC resolutions for LCD TV.
Not applicable to 20” LCD TV
or
Plasma TV
1280 x 768, 60 Hz
1280 x 1024, 60 Hz
1360 x 768, 60 Hz
1
2
HDMI
PC
DVI
Audio
L/R
Connectors
at side of TV
Connectors at rear of
TV (facing downward)