Philips DC177-37 - Manual (Page 15)

English
15
Basic Functions
IMPORTANT:
Before you operate the system, complete
the preparation procedures.
Plug and Play (for tuner installlation)
Plug and Play allows you to store all available
radio stations automatically.
First time setup/power up
1
When you turn on the main supply, " AUTO
INSTALL - PLEASE PRESS PLAY, STOP
CANCEL" is displayed.
2
Press ÉÅ on the system to star t installation.
➜
"
PLUG AND PLAY" .... "INSTALL" is
displayed, followed by "TUNER" and "AUTO".
➜
PROG starts flashing.
➜ The system will automatically store the radio
stations (FM only ) with sufficient signal strength.
➜
When all the available radio stations are
stored or the memory for 40 presets are used,
the last preset radio station will be played.
To reinstall Plug and Play
1
In standby mode, press and holdÉÅ on the
system until "
AUTO INSTALL - PLEASE
PRESS PLAY, STOP CANCEL" is displayed.
2
Press ÉÅ again to start installation.
➜ All previously stored radio stations will be
replaced.
To exit without storing the Plug and Play
● Press 9 on the system.
➜ If you do not complete the Plug and Play
installation, the function will be restarted when
you next turn on the main supply again.
Notes:
– If no stereo frequency is detected during Plug
and Play, "CHECK ANTENNA" will be displayed.
PG 001-026_DC177_37-Eng 2008.2.28, 10:10 15